Ethernet Gateway Components and Overview

Components

Sensor Ports 1, 2, 3, and 4 : Accepts any RJ12 type sensor made for the Ethernet Gateway.

Power Jack : The Ethernet Gateway can be powered by connecting a 5V 1A power supply to a North American electrical outlet.  The power jack accepts DC 2.1/6.3mm coaxial power connectors of 12VDC at 1A.

Reset Button:  The reset button is located in a small pinhole on the bottom of the Ethernet Gateway below the device ID label. Pressing and holding the reboot button for 20 seconds will factory reset the device to its DHCP configuration.

PC Port : This connection is only used for initial setup for Static IP using the web GUI of 10.99.99.1 only unless pre-configured by the manufacturer. Connecting from this port will cause the Gateway to act as a DHCP server and may cause problems on your network.

Internet Port: This Ethernet port is used for a permanent hardwire connection between your Ethernet Gateway and Internet router.

Overview

The Ethernet Gateway (Model # TM-WIFI440-Z) is a remote monitoring system that connects directly to the Internet through Ethernet cable connection (DHCP or Static IP). Connect Wireless Sensors to the Ethernet Gateway to remotely monitor temperature, humidity, and more, and configure alerts when conditions fall outside of your set ranges.

The Ethernet Gateway can use either wired sensors (connected directly to the unit) or wireless sensors. Each Ethernet Gateway unit can be linked up to 15 wireless sensors and up to four wired sensors. Each sensor reading is transmitted to our monitoring dashboard: InsightsTM; and if our monitoring dashboard does not hear from your gateway(s), you will be notified via Missed Report alerts as part of our system Health Check feature.


WARNING:

Changes or modifications not expressly approved by TempAlert could void the user’s authority to operate the equipment.

FCC STATEMENT:

This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Contains Transmitter Module FCC ID: SZ9TMWIFI440Z

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.  However, there is no guarantee that interference will not occur in a particular installation.  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.”
“This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.  These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.  This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.  Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.


Was this article helpful?

Contact Support